English-8
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (
Figure C.2
and
Figure C.3
).
6. Please check that you can still rotate, raise and lower the monitor screen when you have installed the cables.
Figure C.2
Figure C.3
USB Cable
Power Cord
DVI Cable
D-SUB Cable*
1
Power Cord
DVI Cable
D-SUB Cable*
1
USB Cable
DisplayPort Cable
HDMI Cable*
1
*
1
: Cable not included.
7. Slide down the cable cover (
Figure D.1
).
8. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE:
Please refer to Caution section of this manual for proper selection of AC power cord.
9. Turn on the monitor with the front power button (
Figure E.1
) and the computer.
10. No Touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings. For further
adjustments, use the following OSD controls:
• AUTO CONTRAST (Analog input only)
• AUTO ADJUST (Analog input only)
Refer to the
Controls
section of this User’s Manual for a full description of these OSD controls.
NOTE:
If you have any problems, please refer to the
Troubleshooting
section of this User’s Manual.
Figure D.1
Figure E.1
Power Button
Raise and Lower the Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape mode.
To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (
Figure RL.1
).
NOTE:
Handle with care when raising or lowering the monitor screen.
Figure RL.1
