English-17
English
Aspect
DVI1, DVI2, DPORT, OPTION*
4
, PRESET1*
5
, PRESET2*
5
FULL
1:1
ZOOM
NORMAL
HDMI1, HDMI2, HDMI3, HDMI4, PRESET1*
5
, PRESET2*
5
FULL
WIDE
DYNAMIC
1:1
ZOOM
NORMAL
*4: This function depends on which option board you use.
*5: This function depends on INPUT CONFIGURATION setting.
Aspect ratio
of image
Unchanged view*
3
Recommended selection
for picture aspect*
3
4:3
NORMAL
DYNAMIC
Squeeze
FULL
Letterbox
WIDE
*
3
Grey areas indicate unused portions of the screen.
NORMAL:
Displays the aspect ratio the same as it is sent
from the source.
FULL:
Fills entire screen.
WIDE:
Expands a 16:9 letter box signal to fi ll entire screen.
DYNAMIC:
Expands a 4:3 pictures to fi ll the entire screen
with non-linearity. Some of the outside image area will be cut
off due to expansion.
1:1:
Displays the image in a 1 by 1 pixel format.
ZOOM
The image can be expanded beyond the active display area.
The image which is outside of active display area is not
shown.
ZOOM
ZOOM
Power Indicator
Mode
Status Indicator Light
Power ON
Green*
1
Power OFF and Power Save “AUTO
STANDBY”
Power consumption under 0.5 W*
2
Red
Power Save “AUTO POWER SAVE”
Power consumption under 0.5 W
Amber
Power Standby when “SCHEDULE
SETTINGS” enabled
Green and Amber blink alternately
Diagnosis (Detecting failure)
Red Blinking
(See
Troubleshooting
page 49)
*1 If “OFF” is selected in POWER INDICATOR (page 27), the LED will not light when the
LCD monitor is in active mode.
*2 Without any option, with factory settings.
Initial settings
Setting LAN POWER (see page 28) and POWER SAVE (see
page 27) windows appear the fi rst time the power is on.
These settings are only necessary upon initial setup.
However, this message window appears when the power is
on after FACTORY RESET is done.
Using Power Management
The LCD monitor follows the VESA approved DPM Display
Power Management function.
The power management function is an energy saving
function that automatically reduces the power consumption
of the display when the keyboard or the mouse has not been
used for a fi xed period.
The power management feature on your new display has
been set to the “AUTO STANDBY” mode. This allows your
display to enter a Power Saving Mode when no signal is
applied. This could potentially increase the life and decrease
the power consumption of the display.
NOTE:
Depending on the computer and display card
used, this function may not operate.
NOTE:
The monitor automatically goes into OFF at the
preset time period after signal is lost.
MULTI PICTURE MODE
Selects MULTI PICTURE MODE. You can select up to
4 pictures. When MULTI PICTURE is “ON” and PICTURE
NUMBER is 2 PICTURES, the display images are like below.
2
PICTURES
PIP
PBP1
A
B
A
B
When MULTI PICTURE is “ON” and PICTURE NUMBER is
3 PICTURES, the display images are like below.
3
PICTURES
PIP
PBP1
PBP2
PBP3
A
C
B
C
B
A
C
B
A
B
A
C
When MULTI PICTURE is “ON” and PICTURE NUMBER is
4 PICTURES, the display image is set to like below.
4
PICTURES
B
A
C
D
A: PICTURE 1
B: PICTURE 2
C: PICTURE 3
D: PICTURE 4
MULTI PICTURE MODE (See page 25).
