Troubleshooting 8-5
STATUS lamp
indication
Description
Action
Unlit
The server is off-powered.
Power on the server.
POST is in progress.
Wait for a while. The STATUS lamp will light in a
few seconds after POST completion.
A processor error occurred
(IERR).
A processor thermal error
was detected. (Thermal-
Trip)
Cycle power to the server. If POST displays an
error message, take a note on the message and
contact your service representative.
A watchdog timer has timed
out.
A PCI system error occurred.
A PCI parity error occurred.
An uncorrectable memory
error was detected.
An uncorrectable bus error
was detected.
POST terminates with error.
Memory dumping is
requested.
Wait until memory dumping completes.
Lit in amber
A thermal error (critical) was
detected.
Check internal fans for dust or debris. Also
make sure that the fans are firmly connected.
If this error indication persists, contact your
service representative.
A voltage error (critical) was
detected.
Contact your service representative.
A power supply(ies) failed to
operate.
Contact your service representative.
Flashing in
amber
A power alarm was detected
in a power supply unit.
Identify the failed power supply unit and contact
your service representative.
A fan alarm was detected.
Make sure that the fan units are firmly connected.
If this error indication persists, contact your
service representative.
A thermal error (warning) was
detected.
Check internal fans for dust or debris. Also
make sure that the fan units are firmly connected.
If this error indication persists, contact your
service representative.
A voltage error (warning) was
detected.
Contact your service representative.
Summary of Contents for N8100-1220F
