9-36 Upgrading Your Server
Requirements for Hot Add
No boards installed in the same bus
Verify the available slot according to "List of Optional Devices and their Available Slots",
and then hot-add the PCI card.
PCI boards installed on the same bus
Provide Hot Add for PCI boards operating at the same clock.
Status Lamps
Two LED indicators on the back panel indicate the status of the hot-plug PCI add-in boards. You
can check the indication by lamps on the I/O board.
PCI slot Power lamp (green)
Lights when power is supplied normally to the PCI board installed.
PCI slot Fault lamp (amber)
Lights when an error occurs on PCI board or the slot containing the PCI board.
Flashes when the driver is stopped from Windows Server 2003 for Hot Remove or Hot
Replace.
PCI slot Power lamp
PCI slot Fault lamp
Summary of Contents for N8100-1220F
