4-82 Configuring Your Server
Clearing CMOS Data
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switching setting from "Protect" to "Clear".
IMPORTANT:
Use the clip over jumper pins 1 and 2 on the mother board.
Do not lose the clip.
4.
After three seconds later, reinstall the jumper.
5.
Reinstall the server and then turn on the power.
6.
Press
F2
during POST to run the BIOS Setup utility, and configure the mother board
again.
Clearing Password
1.
See the section "Preparing for Installation and Removal" in Chapter 9 to prepare
2.
Remove the left side cover (see Chapter 9).
3.
Change jumper switching setting from "Protect" to "Clear".
IMPORTANT:
Use the clip over jumper pins 1 and 2 on the mother board.
Do not lose the clip.
4.
Reinstall the server and then turn on the power.
5.
Press
F2
during POST to run the BIOS Setup utility, and set the password again.
6.
Remove the left side cover (see Chapter 9).
7.
Power off the server, and change jumper switch setting from "Clear" to "Protect".
8.
Reassemble the server.
Summary of Contents for N8100-1417F
