7-2 Maintenance
CLEANING
Clean the server on a regular basis to keep the server in a good shape.
WARNING
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-
3 to 1-11 for details.
Do not disassemble, repair, or alter the server.
Disconnect the power plug before working with the server.
Cleaning the Server
For daily cleaning, wipe the external surfaces of the server with a dry soft cloth. Follow the
procedure below if stains remain on the surfaces:
IMPORTANT:
To avoid altering the material and color of the server, do not use
volatile solvents such as thinner and benzene to clean the server.
The power receptacle, the cables, the connectors on the front panel
of server, and the inside of the server must be kept dry. Do not
moisten them with water.
1.
Make sure that the server is off-powered (the POWER LED goes off).
2.
Unplug the power cord of the server from a power outlet.
3.
Wipe off dust from the power cord plug with a dry cloth.
4.
Soak a soft cloth in neutral detergent that is diluted with cold or lukewarm water, and
squeeze it firmly.
5.
Rub off stains on the server with the cloth prepared in Step 4.
6.
Soak a soft cloth in water, squeeze it firmly, wipe the server with it once again.
7.
Wipe the server with a dry cloth.
Summary of Contents for N8100-1573F
