1. Installing Internal Optional Devices
Express5800/R120d-2M User’s Guide
91
Chapter 2 Preparations
1.17.3
Installation
Install a PCI card to the PCI riser card in the following procedure.
Important When installing a PCI card, make sure the connector of the board fits the
connector of the riser card.
Note
•
Check the board type (Low Profile or Full Height) which respective PCI riser
card supports and the type of PCI card to be installed.
•
If the battery for RAID controller is installed, refer to
Chapter 2 (1.11 Battery for
RAID Controller).
1. Refer to steps 1 to 6 in
Chapter 2 (1.3 Overview of Installation and Removal)
for preparations.
2. Remove the two screw securing the rise
card. Hold the both ends of the PCI riser
card and lift it off.
3. Confirm the installation position with the reference to the table on
1.17.2 Supported boards and
available slots
.
4. Remove a screw from the PCI rise card
and remove the blank cover.
Note
Keep the removed blank cover for future use.
5. Install a PCI card to the PCI riser card.
When installing the card, position the
terminal part of the PCI card to the PCI
riser card slot and insert it.
Important Do not touch the terminal part of riser cards or PCI cards and the signal pins
of electric parts installed on the board. Installing boards with dirt or oil can
cause malfunction.
Note
•
Make sure that the head of a PCI card bracket is seated into the fixed slot of
fPCI riser card.
•
Depending on type of PCI cards, the terminal part of the PCI card may be too
large to fit in the connector.
•
If you have trouble installing the board, remove the board once and try again. If
you apply excessive pressure on the board, a PCI card or riser card might
break.
