7. Resetting and Clearing the Server
Express5800/R120d-1E, R120d-2E Maintenance Guide
49
Chapter 1 Maintenance
The following instructions show how to clear the CMOS memory and the password.
WARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, refer to
Safety precautions
in
Precautions for Use
in "
User’s Guide
".
•
Do not disassemble, repair, or alter the server.
•
Do not remove lithium, NiMH, or Li-ion batteries.
•
Disconnect the power plug before installing or removing the server.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, refer to
Safety precautions
in
Precautions for Use
in "
User’s Guide
"
.
•
Make sure to complete installation.
•
Do not get your fingers caught.
•
Avoid installing under extreme temperature conditions.
Important Take anti-static measures before operating the server. For detailed
information on static electricity, refer to
Chapter 2 (1.2 Anti-static Measures)
in "
User's Guide
".
•
Clearing CMOS memory
1. Refer to "
Getting Started
"
provided with this server or
Chapter 2 (1. Installing Internal Optional Devices)
in "
User’s Guide
"
to remove the Top Cover.
(Turn off the server, and disconnect the AC power cord from power supply units)
2. Confirm the position of Clear CMOS Jumper.
3. Change jumper swtich settings.
4. Wait about 5 seconds and then put it back.
5. Close Top Cover.
6. Plug in the power cord and turn on the server.
7. POST halts with the following error message
ERROR
8006: System configuration data cleared by Jumper.
Press<F1> to resume, <F2> to Setup
8. Press <F2> key to start the BIOS Setup utility, and then run
Load Setup Defaults
from
Save & Exit
menu.
