4. Names and Functions of Parts
Express5800/R110f-1E User’s Guide
38
Chapter 1 General Description
4.3
Rear View
(1) AC
Inlet
This socket is used to connect the power cord.
(2) Serial port A (COM A) connector
This connector is used to connect devices that support a
serial interface. Note that it is not possible to directly
connect to a dedicated line.
(3) LINK/ACT
LED
(green)
The LED indicates the access status of LAN.
(4) LAN
connectors
LAN connectors that support
1000BASE-T/100BASE-TX/10BASE-T.
If Shared BMC LAN feature is enabled in ROM Utility, LAN
connector 1 can also be used as the management LAN
connector. However, sharing port is not recommended from
the point of performance and security, because LAN port 1
may receive both data.
(5) SPEED LED (green/amber)
The LED indicates the transfer speed of LAN ports.
(6) Display
connector
The connector to connect a display.
(7) DC Power LED (green)
During BMC initialization, this LED lights amber.
This LED
lights green when the power is ON.
(8) USB
connectors
These connectors are used to connect devices that support
the USB interface.
(9) Management
LAN
connector
LAN connector that supports 100BASE-TX/10BASE-T.
This port cannot be used as a data transmission port. This
port is used for connecting to EXPRESS SCOPR ENGINE
3. This port is disabled when Shared BMC LAN feature is
used.
(10) UID (Unit ID) switch/LED (blue)
The switch to turn on and off the UID LEDs provided at the
front and rear of the server. Pressing the switch once turns
on the UID LED and pressing once more turns off the LED.
(11) PCI slot
The slot is used to install the low profile type PCI board.
The sequential numbers indicate the corresponding slot
numbers.
(2)
(3) (4) (5) (3) (4) (5)
(6) (8)
(7)
(9)
(4)
(5)
(10)
(11)-2
(1)
(11)-1
<Non-Redundant Power Supply Unit Model>
<Redundant Power Supply Unit Model>
(2)
(3) (4) (5) (3) (4) (5)
(6) (8)
(7) (9)
(4)
(5) (10)
(11)-2
(1)
(11)-1
(1)
