1. Installing Internal Optional Devices
Express5800/R110f-1E User’s Guide
61
Chapter 2 Preparations
1.9.4
Removal
Remove a DIMM in the following procedure.
Note
•
When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is
installed.
•
At least one DIMM needs to be installed for the server to operate.
1.
Refer to steps 1 to 4 in
Chapter 2 (1.3 Overview of Installation and Removal
for preparations.
2.
Lift the duct off the server.
3.
Open levers on left and right sides of
DIMM slot to unlock DIMM.
4.
Remove DIMM by pulling it up straight.
5.
Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
6.
Confirm that no error messages are displayed on POST. If any error message is displayed, refer to
Chapter 3 (1. Post Error Message)
in "
Maintenance Guide
".
7.
Run the SETUP utility, select
Memory Configuration
from the
Advanced
menu, and then specify
Yes
for
Memory Retest
. After that, select
Save Changes and Exit
to reboot.
8.
Set the paging file size to the recommended value (Total memory size x 1.5) or more.
If using a Windows OS, refer to
Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information))
in "
Installation Guide (Windows)
".
For other OS, consult the manual provided with the operation system or contact the store where you
purchased it or your maintenance service company.
