1. Installing Internal Optional Devices
Express5800/R110f-1E User’s Guide
86
Chapter 2 Preparations
1.12.3
Installation
Install a riser card to a PCI card in the following procedure.
Important When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type (low profile or full-height type) which respective riser card
supports and the type of PCI card to be installed.
1. Refer
to
Chapter 2 (1.3 Overview of Installation and Removal)
for preparations.
2. Refer
to
Chapter 2 (1.6 Removing the Top Cover)
to remove the top cover.
3.
Remove the screw securing the riser
card. Hold the both ends of the riser card
and lift it off.
Note
Be careful not to contact with other parts.
4.
Confirm the installation position with the reference to the table on the previous pages.
5.
Remove the screw from the riser card
and remove the blank cover.
Note
Keep the blank cover for future use.
6.
Install a PCI card to the riser card.
When installing the card, position the
terminal part of the PCI card to the riser
card slot and insert it.
PCI 1B slot
PCI 1A slot
