NEC N8101-601F User Manual Download

Page: 7 / 8

856-129808-101-00

8. Put the heat sink on the processor and fix the heat sink with four screws.

Temporarily tighten the four screws diagonally, then tighten them securely.

Make sure that the screw aligns with the screw hole. If not, the screw may damage the motherboard.

Important



Use the heat sink that comes with your server, when you install the CPU1
(Basic).



Need the additional heat sink (N8101-609F), when you install the CPU2
(Optional).

Note

Make sure the location to put the heat sink.

Summary of Contents for N8101-601F

Page 2: ...the server in the place where dust water or liquid may pour Do not use the server in the place where the strong electromagnetic waves generate Do not touch the terminals of the processor and the processor socket Transfer to Third Party Make sure to provide this manual and all the accessories along with the product to a third party ...

Page 4: ...he locking mechanism toward right Hold the handle and pull out the server module horizontally Important If you remove the server module from module enclosure wait at least 30 seconds before insert it again into enclosure ２ Install the Xeon Processor Kit Follow steps below to install the processor 1 Locate the CPU socket to which you are going to install a processor CPU2 CPU1 ...

Page 5: ...cover from the CPU socket Note Keep the removed protective cover for future use 3 Push down the socket lever once to unlatch it from the hook then slowly open the lever until it stops 4 Lift the plate Important Do not touch the socket contacts ...

Page 7: ...lly then tighten them securely Make sure that the screw aligns with the screw hole If not the screw may damage the motherboard Important Use the heat sink that comes with your server when you install the CPU1 Basic Need the additional heat sink N8101 609F when you install the CPU2 Optional Note Make sure the location to put the heat sink ...