NOTE:
Select an arm support appropriate to the rack (when installing the
server on NEC rack of which distance between the mount faces at the front
and rear of the rack is other than 743 mm or non-NEC rack).
Rack
700
～
743mm
Server
Server
Cable arm
Cable arm
Arm support (1)
Rack
Sliding rail
Sliding rail
Arm support (2)
743
～
900mm
Install the arm support in the
nearest distance from the cable
arm of the server side.
3.
Make sure installation of cable arm.
While the server is being fixed to the rack, you need to rotate and open the cable arm toward the rear
of the server when connecting/disconnecting cables to/from the server or replacing the power unit.
Make sure that the cable arm can rotate smoothly. In addition, make sure that the cable arm moves
smoothly when pulling out the server from the rack.
When the distance between the
mount faces at the front and rear
of the rack is 700 to 743 mm:
When the distance between the
mount faces at the front and rear
of the rack is 743 to 900 mm:
11
Summary of Contents for N8143-93
