Safety Consideration
67
For Correct Operation
To operate the Built-In AIT correctly, observe the following points. For considerations on handling
the AIT data cartridge, refer to the chapter “AIT Data Cartridge”.
• Set the Built-In AIT’s SCSI ID so that it will not duplicate with SCSI ID of other SCSI equip-
ment.
→
Otherwise, an operation error will occur.
• Do not turn off the basic processing unit when the TAPE MOTION LED on the front of the
Built-In AIT is blinking.
→
This may cause a machine failure or damage of backup data.
• Do not store the Built-In AIT in a place subject to corrosive gas, chemicals or splash of chemi-
cals.
→
A Built-In AIT part may be deformed or damaged and may not be able to operate correctly.
• Do not store the Built-In AIT in a place subject to strong vibrations.
→
This may cause a machine failure.
• As the data cartridge set in the Built-In AIT, use our “AIT Data Cartridge” (models: AIT1 (with
the N8151-34B); AIT1 or 2 (with the N8151-46A)).
→
If you use a data cartridge of other manufacturer, a read/write error may occur.
• Clean the Built-In AIT on a regular basis.
→
For details about cleaning the Built-In AIT, see “Cleaning” (page 99).
• When cleaning the Built-In AIT, use our “AIT Cleaning Cartridge”.
→
If you use a cleaner of other manufacturer, a machine failure may occur.
• Do not transport the Built-In AIT with a data cartridge inserted.
→
Shocks may damage the Built-In AIT and/or data cartridge.
• Eject the data cartridge when you are done performing a backup.
→
This may shorten the operational life of the data cartridge and/or cause malfunctions.
Summary of Contents for N8151-34B
