Safety Consideration
61
For Correct Operation
To operate the N8151-50F Built-In AIT correctly, observe the following points. For considerations
on handling the AIT data cartridge, refer to the chapter “AIT Data Cartridge”.
• Set the N8151-50F Built-In AIT’s Jumper so that it will not duplicate with Jumper of other IDE
equipment.
→
Otherwise, an operation error will occur.
• Do not turn off the basic processing unit when the BUSY LED on the front of the Built-In AIT
is blinking.
→
This may cause a machine failure or damage of backup data.
• Do not store the Built-In AIT in a place subject to corrosive gas, chemicals or splash of chemi-
cals.
→
A Built-In AIT part may be deformed or damaged and may not be able to operate correctly.
• Do not store the Built-In AIT in a place subject to strong vibrations.
→
This may cause a machine failure.
• As the data cartridge set in the Built-In AIT, use our “AIT Data Cartridge (model: AIT1)”.
→
If you use a data cartridge of other manufacturer, a read/write error may occur.
• Clean the Built-In AIT on a regular basis.
→
For details about cleaning the Built-In AIT, see “Cleaning” (page 87).
• When cleaning the Built-In AIT, use our “AIT Cleaning Cartridge”.
→
If you use a cleaner of other manufacturer, a machine failure may occur.
• Do not transport the Built-In AIT with a data cartridge inserted.
→
Shocks may damage the Built-In AIT and/or data cartridge.
• Eject the data cartridge when you are not using the Built-In AIT or before you turn it off.
→
This may shorten the operational life of the data cartridge and/or cause malfunctions.
• Do not leave a data cartridge protruding from the Built-In AIT data cartridge slot for prolonged
periods.
→
This may shorten the operational life of the data cartridge and/or cause malfunctions.
