AIT Data Cartridge 91
Precautions on entry to label
• To represent the data contained in the AIT data cartridge, use a label which can be easily
replaced and no adhesion trace is left.
• To change the label indication, do not erase it with an eraser but peel the old label and paste a
new one. (The INDEX labels are provided with the AIT data cartridge.)
• Pasting the label in the position specified in the previous section. To replace the label, peel the
old label and paste a new one.
• When using a label other than the specified INDEX label, its size should be the same as the
specified label.
• Enter the date when starting to use the cartridge in the provided INDEX label. It will help you
check the AIT data cartridge service life.
Write-protect
By setting the write-protect plug as
shown at right, the tape data can be
protected.
When you do not want to erase the
written data, set the plug to the “SAFE”
position (write disable). To enable write
to the tape, set the plug to the “REC”
position (write enable).
AIT1
Write enable Write disable
Write-protect plug
