76 Built-in AIT
Mounting on the basic processing unit
Caution
Turn off the power before installing or removing the device
Always be sure to turn off the main power and unplug the power cord from the
AC outlet before installing/removing this device or connecting any cables.
There is a risk of electric shock if this device in installed or removed or if any
cables are connected while the power cord is still plugged into an AC outlet.
The procedure for installing the drive in a server is as follows.
Hint
✎
Some servers require the rails to be used. For details on how to install the rails, refer to the
server's operating manual.
1
Install the N8151-50F Built-In AIT
under the CD-ROM/RW drive.
Important
• When using the rails with this
device, use the screw holes in the
front cover illustrated in Fig. 1 (see
Fig. 2). (Perform the same operation
on the opposite side. Secure two
screws on each side, four screws
total.)
In some cases the rails may extend
all the way to the front cover
molding. This causes no problems.
When using the rails, adjust their
mounting positions so that the front
cover of this device is aligned with
the front covers of other standard
components (such as the CD-ROM drive).
(The shape of the rails varies according to the model of the device.)
Screw hole
Front cover
Fig. 1
Rail
Front cover
Fig. 2
