47
Part Name and Function
The following describes the names of the parts used to install or handle the Built-in
DVD-RAM drive and their locations.
<Front View>
1 Tray
Place on which a disk is put
The tray is moved if you press the eject button or push the tray under the power-on status.
(The tray does not move under the power-off status.)
2 Eject
button
Press this button to insert or eject a disk into or from the Built-in DVD-RAM drive. (The
button does not operate if the power of the Built-in DVD-RAM drive is OFF or the relevant
program prohibits it from operating.)
3
Manual emergency ejecting hole
Insert a pin (such as a clip extended straight) into this hole to eject the tray manually. (The
hole is provided to eject the tray manually when the eject button and the relevant software
are not available for the ejection.)
4 Busy
indicator
The indicator operates as shown in the table below under the power-on status.
Inserted media
Operation status
Indication
Writing Blinking
Reading On
DVD-RAM disk
Stand-by Off
Reading On
CD/DA or similar disk
Stand-by Off
No disk insertion
—
Off
Disk inserting/ejecting
—
Blinking
1
4
3
2
Summary of Contents for N8151-74
