External AIT 75
Important
• When the BUSY LED is lit or blinking, do not turn off the basic processing unit. This may cause
a malfunction or damage data.
• To avoid malfunction, do not transport this unit with the data cartridge installed.
LED indication
Three LED on the External AIT’s front side signal the status of the drive and the AIT data
cartridge.
LED name
Indication status
Description
BUSY LED
OFF
–
ON
Transmitting or receiving the data now
Blink
The data is normally read/written from/to the
data cartridge set in the External AIT.
TAPE LED
OFF
The data cartridge is not set.
ON
The data cartridge is set.
Blink (at a given interval)
The data cartridge is being set or ejected.
The data cartridge set in the External AIT is
deteriorated.
STATUS LED OFF
The data cartridge set in the External AIT is
ready to write data.
ON
The data cartridge set in the External AIT is
not enabled to write data (write-protected).
The External AIT head needs cleaning.
Blink (at a given interval)
During the head cleaning, the cleaning
cartridge tape comes to the end.
The drive is broken.
Reading/writing data
To read/write the data from/to the AIT data cartridge, see the instruction manual provided with the
backup application.
Blink (repeating a long ON
and a short OFF)
Blink (repeating a short ON
(once or twice) and a long ON)
Blink (repeating a long ON
and a short ON)
Summary of Contents for N8160-48
Page 2: ......
Page 43: ...仕 様 41 198 0 mm 64 5 mm 246 mm 重量 2 3 kg 寸法 重量 ...
Page 87: ...Specification 85 Dimensions weight 64 5 mm 198 0 mm 246 mm Weight 2 3 kg ...
Page 95: ......
