System Configuration 4-41
2.
Press and hold down the
Ctrl
key and press the
C
key.
The SAS Configuration utility starts up with the “Adapter List” menu displayed.
Quitting the SAS Configuration utility
The following section describes the procedures to quit the SAS/ Configuration utility.
1.
Keep pressing
ESC
key until the “Adapter List” menu appears.
If you changed each menu setting of “SAS Configuration Utility,” a message appears to prompt
whether you want to save the changes made.
Select the item you want and press
Enter
key when the message is displayed.
xxxxxxxx xxxxxxxx changes have been made
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
2.
If you press
ESC
key on the “Adapter List” menu, a massage prompts you whether or not to
save the changes. Select the item you want and press
Enter
key when the message is displayed.
Are you sure you want to exit?
Cancel Exit
Save changes and reboot.
Discard changes and reboot.
Exit the Configuration Utility and Reboot
The changes made on SAS Configuration Utility will be effective after the reboot of the server.
Summary of Contents for N8800-162F
