5-18 Installing and Using Utilities
LAN Monitoring Threshold
Because a hardware trouble on the network is detected at driver level, NEC ESMPRO Agent does
not monitor line faults. Thus, the value set for “Line fault occurrence rate” of a [LAN] tab of [NEC
ESMPRO Agent properties] in the control panel is not used.
Change of SNMP Community
If the security setting of the SNMP Service of a system, where the NEC ESMPRO Agent is installed,
is changed from the default “public” to a community name, change the community settings of the
NEC ESMPRO Agent, too.
1.
Login as a root user.
2.
Go to the folder where NEC ESMPRO Agent control panel is installed.
# cd /opt/nec/esmpro_sa/bin
3.
Start the control panel.
# ./ESMagntconf
The control panel is displayed.
4.
Select [General].
The [General property] is displayed.
5.
Select a desired community name from the [SNMP Community] list box in [SNMP
Setting] of the [General] sheet.
6.
Click [OK] to terminate the operation.
Summary of Contents for N8800-162F
