Maintenance 6-7
SYSTEM DIAGNOSTICS
The System diagnostics runs several tests on the server.
Select [Tool menu] - [Test and diagnostics] in the NEC EXPRESSBUILDER to diagnose the
system.
Test Items
The following items are tested in system diagnostics.
Memory
CPU cache memory
Hard disk drive used as a system
IMPORTANT:
When executing the system diagnostics, make sure to remove the LAN cable. Executing the
system diagnostics with the LAN cable connected, the network may be influenced.
TIPS:
On checking the hard disk drive, no data is written into the disk.
Startup and Exit of System Diagnostics
Follow the steps below to start the system diagnostics. (If the server is running, shut it down, and
execute Step 1 through Step 12.)
1.
Shutdown the OS, and power off the server. Then, unplug the power cord.
2.
Disconnect all the LAN cables from the server.
3.
Plug the power cord and power on the server.
4.
Use the NEC EXPRESSBUILDER DVD to start the system.
5.
Select [Tool menu].
TIPS:
If the system displays the [Language Selection] menu, select [English].
Summary of Contents for N8800-162F
