CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS
PN-CC01 (ETHER)
NEAX2000 IVS
2
Installation Procedure Manual
ND-70928 (E), Issue 1.0
Page 251
NOTE 1: When the power is on, flip the MB switch to ON (UP position) before plugging/unplug-
ging the circuit card.
NOTE 2: Each equipment must have a unique MAC address to distinguish between systems.
Therefore, when more than one PBX is installed in the same network, assign the lower
4 digits of the following MAC address by SW1 and SW2 to prevent duplicate address-
es.
00004CA4
XX
XX
(HEX)
According to the switch setting of SW2 (D7-D0)
According to the switch setting of SW1 (D15-D8)
Fixed