NEAX2000 IVS Retrofit System Guide
Page 4
ND-71075 (E), Issue 1.0
CHAPTER 1 GENERAL INFORMATION
Hardware/Software Requirements
HARDWARE/SOFTWARE REQUIREMENTS
To upgrade the former system, the following hardware and software must be changed.
NOTE 1: As the Data Base Module (DBM) for WCS Multi-Site Roaming (PCS type), SPN-AP00A
DBM (AP) is used for the Retrofit system.
NOTE 2: The MAT program for former system cannot be used for the Retrofit system.
MATWorX for NEAX2000 IVS
2
/NEAX7400 ICS M100MX must be used.
NOTE 3: The MAT CA-P/R for PN-CP03/PN-CP07 can be used for the Retrofit system.
NOTE 4: The BUS, power, Application Processor, Line/Trunk cards for the former system can
be used for the Retrofit system, except for the cards described above.
NOTE 5: PN-8LC/8COT cards cannot be used on 64-port PIM.
NOTE 6: PN-4DAT card cannot be used on 64-port PIM.
Table 1-1 Required Hardware/Software
ITEM
FORMER SYSTEM
RETROFIT SYSTEM
MP
(including MP
program)
PN-CP00
PN-CP00-B
PN-CP00-C
PN-CP03
PN-CP03-C
PN-CP07
PN-CP07-C
PN-CP16
FP
PN-CP01
PN-CP17
SPN-AP00A MPC-D (AP) or
earlier
SPN-AP00B MRC (AP)
Expansion Memory
for AP00
PN-ME00-C or earlier
PZ-M537
CCH
SPN-SC00 CCH-C (AP) or
earlier
SPN-SC00 CCH-D (AP)
MAT Program
SA-969 SHS MAT PROG-IA3
SA-643 SHS MAT PROG-IA1
MATWorX32
SA-1040 IXS MAT PROG-IA1
MATWorX Suite
MAT Cable
MAT CA-M
MAT CA-Q
MAT CA-S
MAT CA-P
MAT CA-R
MAT CA-P
MAT CA-R
MAT CA-T
