CHAPTER 3 SYSTEM DATA PROGRAMMING
– 221 –
ND-71503(E) Rev.5.0
9pch3002.fm
(3) FAX Protocol, FAX Payload size, Jitter Buffer settings for location group
To provide each location group with the FAX over IP feature, in addition to the “LOCATION DATA
ASSIGNMENT”, do the following programming.
DESCRIPTION
DATA
Assign the FAX control information list to
each location group number assigned by
CM8A Y=5000-5255/CM0A Y=09.
NOTE 1:
Follow the initial data setting usual-
ly.
NOTE 2:
When using the PN-8IPLA (IP-
PAD) card, do not set the second
data to 0 (Fixed list 0).
NOTE 3:
When providing the FAX communi-
cation (G.711 pass-through) with
the PN-32IPLA-A card, set the sec-
ond data to 1 (Fixed list 1), or set the
second data to 4-7 (Programmable
list 4-7) and then set CM67 Y=21-
24.
[Series 3300 software required]
NOTE 4:
When providing the FAX communi-
cation (G.711 pass-through) with
the PN-32IPLA-A card in the system
using the Series 3200 R6.2 software
or before, set the second data to 4-7
(Programmable list 4-7) and then
set CM67 Y=21-24.
[Series 3300 software required]
•
(1)
(2)
Y=20
XXZZ
XX: 00-63: Location No. of group
ZZ: 00-63: Location No. of group
0: Fixed list 0 (See the table below)
1: Fixed list 1 (See the table below)
2: Fixed list 2 (See the table below)
3: Not used
4-7: Programmable list 4-7 (depends on the
setting of CM67 Y=21-24)
NONE : When using PN-32IPLA-A card:
Fixed list 0 (See the table below)/
When using PN-8IPLA card:
Fixed list 1 (See the table below)
START
CM67
Fixed list 0
Fixed list 1
Fixed list 2
FAX Protocol
T.30
G.711
G.726
FAX Payload Size
–
40 ms.
40 ms.
Minimum Jitter Buffer
0 ms.
120 ms.
120 ms.
Maximum Jitter Buffer
0 ms.
120 ms.
120 ms.
A
SEPTEMBER/15/2004
IP FEATURE PROGRAMMING
CÔNG TY VIỄN THÔNG VIỆT PRO
Chuyên phân phối tổng đài NEC
http://vietpro.com.vn