CHAPTER 3 SYSTEM DATA PROGRAMMING
– 111 –
ND-71503(E) Rev.5.0
9pch3001.fm
(1) Main Site Constitution Data Assignment
DESCRIPTION
DATA
Assign the FP number to the FP (Virtual FP/FP
card/MP built-in FP) or AP number to the AP
(Virtual IPT).
NOTE 1:
To control a D
term
IP, assign the sec-
ond data “00” to the FP number of
Virtual FP.
NOTE 2:
To control an IP-PAD, assign the
second data “00” to the FP number
of FP card/MP built-in FP.
NOTE 3:
To control a Virtual IPT, assign the
second data “38” to the AP number
of Virtual IPT.
NOTE 4:
Two Virtual AP numbers for the vir-
tual IPT can be set to the system.
•
(1)
(2)
Y=0
00-59: FP No.
00
: FP (Virtual FP/FP card/MP built-
in FP)
NONE : No data
(1)
(2)
04-15, 20-59: AP No.
38
: Virtual IPT
NONE : No data
Assign the main site number “00” and the
Physical PIM/Virtual PIM number controlled
by the FP or Virtual PIM number that accom-
modates the Virtual IPT to the FP/AP number
assigned by CM05 Y=0.
NOTE:
For Virtual IPT, set the Virtual PIM
number 12, 13 to the Virtual AP
number.
After setting the Virtual PIM number
12, set the number 13, if required.
[For Series 3200 R6.2 software or Series
3300 software]
•
(1)
(2)
Y=8
00-59: FP/AP No.
XX ZZ/ZZZZ (Site No. + PIM No.)
XX
: 00: Main Site
ZZ
: 00-15, 99: Physical PIM No./
Virtual PIM No.
ZZZZ
: 0001/0203/0405/0607: PIM No.
for 2 PIMs designation
NONE : See
.
START
CM05
INITIAL
INITIAL
A
SEPTEMBER/15/2004
REMOTE PIM OVER IP DATA ASSIGNMENT
CÔNG TY VIỄN THÔNG VIỆT PRO
Chuyên phân phối tổng đài NEC
http://vietpro.com.vn
