CHAPTER 3 SYSTEM DATA PROGRAMMING
– 142 –
ND-71503(E) Rev.5.0
9pch3001.fm
D
term
IP LOGIN/LOGOUT OPERATION
To connect the D
term
IP to the network, registration of the ID for each D
term
IP is required.
To provide security, passwords for D
term
IP can be registered to the system that administers and identifies
the password.
Follow the registration procedure as shown below.
D
term
IP Login
NOTE:
The way of ID registration is determined by CM08>513 and CM15 Y=480.
Before registering the ID, program the system data. See
(1) Automatic Login Mode (Authentication by MAC Address)
NOTE 1:
Do the following procedure under On-Line mode of the MP card.
NOTE 2:
To save the data registered by the following operation to your PC, select “Other” from the pull-
down menu of the area name and input “80” in Area number on the Save/Load/Verify dialog of
the MATWorX program.
The data cannot be saved by the basic area name “All office data for MP (Basic + Option)” on
the Save/Load/Verify dialog.
NOTE 3:
To load the registered data from your PC, reset the MP card after loading operation of the
MATWorX.
It takes 5 minutes to start up the D
term
IP after MP card is reset.
When you start up the D
term
IP, the following appears on the LCD.
D
term
IP Display (ID Registration without Password)
STEP1:
Enter the station number of the D
term
IP to the first row behind “Login :”.
STEP2:
Press
Set
key (soft key).
L o g i
n
:
P a s s w d :
C a n c e
l
B K
S e
t
O K
FEBRUARY/28/2002
D
term
IP LOGIN/LOGOUT OPERATION
CÔNG TY VIỄN THÔNG VIỆT PRO
Chuyên phân phối tổng đài NEC
http://vietpro.com.vn
