CHAPTER 3 SYSTEM DATA PROGRAMMING
– 204 –
ND-71503(E) Rev.5.0
9pch3002.fm
Call Forwarding-Logout (D
term
IP)
[Series 3100 software required]
General Description
This feature allows a call terminated to a D
term
IP in logout status to be forwarded to a predesignated sta-
tion, outside number, Attendant Console or Digital Announcement Trunk (DAT). This feature is also ap-
plicable to the D
term
IPs that the LAN cable is pulled out or the power is off.
Station Application
D
term
75 (Series E)/D
term
85 (Series i) Terminals with LCD equipped for IP Adapter units (Peer-to-Peer ver-
sion), D
term
IP, D
term
IP INASET, D
term
SP20/D
term
SP30.
Service Conditions
1.
This feature is effective when a D
term
IP is in the following logout conditions.
– When the D
term
IP is logged out by Logout Feature Access Code.
– When Login Dialog is displayed on the D
term
IP.
– When “Connecting.....” is displayed on a D
term
IP.
– When the D
term
IP is in the Configuration mode (When the D
term
IP is in the Configuration mode
for more than two minutes, the D
term
IP is to be Logout status).
– When the D
term
IP is reset by pulling out the LAN cable (When the LAN cable is pulled out for
more than two minutes, the D
term
IP is automatically reset).
– When the power of the D
term
IP is OFF.
– When the PBX system is reset by power failure or other reasons.
2.
When a D
term
IP is in a Logout status, calls cannot be terminated to the sublines on that D
term
IP.
3.
When a D
term
IP in a Logout status is in a multiline group, a call to that D
term
IP cannot ring other sta-
tions in that multiline group.
4.
A call forwarding destination can be a station, a Voice Mail System, an outside number, an Attendant
Console, and a Digital Announcement Trunk (DAT).
5.
When the call forwarding destination is a station, an outside number or an Attendant Console, this
feature can be set by dialing Call Forwarding-Logout Feature Access/Cancellation Code or data as-
signment from a MAT/CAT. Setting by Feature Access Key is not supported.
6.
When the call forwarding destination is an outside number, there are following conditions.
a. When a D
term
IP in a Logout status receives an incoming trunk call and call forwarding destination
is an outside number (tandem connection), the call is forwarded or not in accordance with the re-
striction data for tandem connections (CM36). When the tandem connection between the incoming
trunk route and outgoing trunk route is allowed by system programming, the call is forwarded to
the outside number. When it is restricted, the caller will hear ROT.
b. Maximum 250 outside numbers can be assigned as call forwarding destinations (There is no lim-
itation when a station is designated as a call forwarding destination).
JANUARY/16/2004
IP FEATURE PROGRAMMING
CÔNG TY VIỄN THÔNG VIỆT PRO
Chuyên phân phối tổng đài NEC
http://vietpro.com.vn