D-29
Look at the stop position of the Take-Up Roller from Clutch Gear side.
(6)
Disassembly of the Fusing Unit
NOTE
•
The Fusing Unit is extremely hot immediately after the Power Switch has been turned
OFF. Allow a sufficient time to let it cool down before starting the procedure to prevent
burn.
1. Remove the Fusing Unit.
☞
E-7
After setting replaced Paper Take-Up Clutch Gear
(Torque Limiter) to the shaft, Rotate the Paper Take-
Up Clutch Gear by hand (Need to be released Sole-
noid Flapper).
4136D060AA
1. When the Roller is lent to clockwise, move the
coupling Gear to A direction.
4136D046AA
2. When the Roller is lent to counter clockwise,
move the coupling Gear to B direction.
4136D045AA
2. Remove the two screws.
3. Remove the Fusing Unit is divided into the Upper
Fusing Roller section and Lower Fusing Roller
section.
4136D021AA
Upper Fusing
Roller section
Lower Fusing
Roller section