125
5. Using On-Screen Menu
Selecting the Signal Format [SIGNAL SELECT(COMP3)]
When an output device is connected to the COMPUTER 3 video input connectors, this sets the input signal.
RGB/COMPONENT ��������RGB and component signals are identified automatically�
VIDEO ���������������������������This switches to the video signal�
NOTE: When a video cable (commercially available) is connected to the COMPUTER 3 video input connectors’ G/Y connector, video
signals can be projected. In this case, set to “VIDEO”.
[SEAMLESS SWITCHING]
When the input connector is switched, the image displayed before switching is held to switch to the new image without
a break due to absence of a signal.
[COLOR SYSTEM]
This feature allows you to select the TV video signal, which differs from country to country (NTSC, PAL, etc.).
This is set to [AUTO] by factory default. Set this if the projector cannot identify the signal automatically.
Setting for the Optional Board [SLOT POWER]
When using the optional board such as SB-01HC installed in the slot, set the following options.
PROJECTOR ON �����������������
This feature will turn on or off the power to the optional board.
OFF: Forcibly turn off the power to the optional board installed in the slot�
ON (Default): Turn on the power to the optional board installed in the slot�
PROJECTOR STANDBY �������
This feature will automatically enable or disable the optional board installed in the slot
when the projector is in standby.
DISABLE: Select this option to disable the optional board in the projector standby�
ENABLE (Default): Select this option to enable the optional board in the projector standby�
NOTE:
• Select [OFF] when the optional board is not installed into the slot.