22
3. Projecting an Image (Basic Operation)
2
1
4
3
Adjustable Tilt Foot
Ventilation
outlet
Adjustable Tilt
Foot Lever
Adjust the Tilt Foot
1. lift the front edge of the projector.
CAUTION:
Do not try to touch the ventilation outlet during Tilt Foot adjustment
as it can become heated while the projector is turned on and after it
is turned off.
2. Push up and hold the adjustable tilt foot lever on the front of
the projector to extend the adjustable tilt foot.
3. lower the front of the projector to the desired height.
4. release the adjustable tilt foot lever to lock the adjustable tilt
foot.
The tilt foot can be extended up to 1.6 inch/40 mm.
There is approximately 10 degrees (up) of adjustment for the front of
the projector.
Rotate the rear foot to the desired height in order to square the image
on the projection surface.
CAUTION:
• Do not use the tilt-foot for purposes other than originally intended.
Misuses such as using the tilt foot to carry or hang (from the wall or
ceiling) the projector can cause damage to the projector.
Adjusting the left and right tilt of an image [Rear foot]
1. remove the spacer (black rubber) from the rear foot.
Keep the spacer for future use.
2. rotate the rear foot.
The rear foot can be extended up to 0.4 inch/10 mm. Rotating the rear
foot allows the projector to be placed horizontally.
NOTE: After using the projector, attach the spacer to the rear foot.
Spacer (black
rubber)
Rear foot
Up
Down
