18 Section 3 Control Panel
Normal Setting Mode Description of Memory Switch Settings
The normal setting mode has six groups of memory switch settings:
Group A: Print mode
Group D: Interface
Group B: Format
Group E: Horizontal alignment
Group C: Paper handling
Group F: Print reset settings
Table 3-2 describes the switch
in each group. Values put in the brackets
denote the factory default setting. See the menu
three
on page 15 for selectable
entries in each mode.
Table Switch Functions
Item
Function
Group A:
Print Mode
Language char. sets
2. Shape of zero
3.
Quiet mode
Selects
character set default. [U.S.A.]
Selects the shape of zero. [0]
Selects the
quiet mode, in
the printer
at a reduced
speed and noise level. [disable]
4. Graphics print direction
Selects
print direction
[unidirectional]
5. Hex dump mode
Selects or cancels the hex dump mode. [disable]
Group B: Format
Form feed length
2. Skip over perforation
3. 0 margin emulation
4. CR function
5. LF function
Selects the form feed
for continuous paper in
inches.
in.]
in.]
Selects or cancels inch skip-over perforation at power-up. [no skip]
or cancels 0 margin emulation. [disable]
Selects CR code
function.
[CR only]
[CR
PRINTOUT]
Selects LF
function. [CR t
Group C: Paper Handling
Top margin (cut sheet guide)
2. Top margin (push tractor)
3. centre pos.
4. S/F left margin
Selects the top margin of the cut sheet guide in inches.
in.]
the top edge of the paper to the middle of the first
print fine.
Selects the margin of the push tractor in inches.
in.]
Distance from the top edge of the paper to the middle of the first
print line.
Selects the
position of the cut sheet. [column
Selects the left margin in a unit of column when the sheet feeder is
installed.
