3
English
Attaching speakers to a plasma monitor
The speakers are divided into a right (R) and left (L) speaker.
When attaching the speakers, be sure to check the labels located on the rear of the speakers as well as the markings (R/L)
written on the attachment plates.
1
Remove the protective tape from the cushions and then
attach the cushions to the sides of the speakers in the
locations indicated in the diagram below.
Cushions
2
Attaching the attachment pieces to the locations shown
in the drawing of the plasma monitor with screws (M5
×
12 mm) (8 locations).
Check the marks on the attachment pieces (TL, TR, BL,
BR) and the plasma monitor attachment locations.
3
Loosely screwing the screws (M5
×
12 mm) into place on
the top attachment pieces (2 locations).
Note
To install the plasma monitor on a wall, first attach the
attachment pieces to the plasma monitor then install it on
the wall. After installing the plasma monitor on the wall, it
may be impossible to tighten the screws on the attachment
pieces.
4
1
Attaching the screws (M5
×
12 mm) that have been
loosely screwed into place on the hooks on top of the
speakers.
2
Loosely screw the screws (M5
×
12 mm) into place
with the screw holes on the attachment pieces on the
bottom aligned with the holes in the hooks on the
bottom of the speakers.
