Section 3
Options
OverDrive Processor Troubleshooting
If a fault occurs at power-on, verify that the installation was performed correctly. One beep
indicates that the computer has completed its power-on self-test. If intermittent beeping oc-
curs, turn off the computer and try again. If the beeping persists, see Section 4, Mainte-
nance and Troubleshooting.
Table Section 3-1 summarizes problems that may develop after installing a OverDrive proc-
essor and lists in sequential order suggested corrective actions.
Table Section 3-1 OverDrive Problems and Solutions
Problem
Symptom
Solution
No power
Power lamp on computer
status panel will not light.
1
. Check that the power cord is plugged into the
AC connector on the computer. Check that the
other end of the cord is plugged into a live
properly grounded AC power outlet.
Operating
system does
not boot
An invalid configuration
message is displayed.
1
. Press
F2
to run setup and view parameters.
OverDrive
Processor
malfunction
Software does not see
OverDrive Processor.
1
. Reseat the OverDrive Processor.
2
. Check the setup parameters
3
. Check the jumper settings (see Section 2).
4
. Replace OverDrive Processor.
5
. Replace system board.
Keyboard or
mouse
malfunction
Monitor has prompt, but
cannot input data.
1
. Check that the keyboard is plugged in.
2
. Check that the mouse is plugged in.
Summary of Contents for PowerMate 466M
Page 10: ...Contents xiii ...
Page 176: ...Connector Pin Assignments A 15 ...