Installing Options 5-11
Chassis Floor
Before replacing the system board or expansion boards, remove the
minitower chassis floor. The chassis floor and the stand are usually
removed as a unit.
Removing the Chassis Floor
To remove the minitower chassis floor, perform the following steps. (Do
not remove the stand from the floor before removing the floor. Unless
stated otherwise, these instructions should be performed with the stand
attached to the minitower chassis floor.)
1.
Remove the minitower cover (see “Removing the Minitower
Cover”).
Note
Do not remove the stand from the floor when removing the floor.
The floor can be removed with the stand attached.
2.
Place the system unit on its right side.
3.
Loosen the thumbscrew holding the floor to the chassis.
Locating the chassis floor thumbscrew
A – Thumbscrew