Installing Options 5-13
Removing the Stand
Unless there is a specific need to remove the stand from the minitower
chassis floor (if the system is being packed for shipment, for example),
keep the stand attached to the chassis floor.
To remove the stand, use the following steps.
Keep the system unit in the stand unless the
computer is being prepared for shipment. The stand is designed to keep
the unit from tipping over.
1.
Remove the minitower cover (see “Removing the Minitower
Cover”).
2.
Hold the stand in place, press down on the locking tab, and slide the
system unit back about one-half inch. This unlocks the tabs
connecting the stand to the chassis slots.
Removing the stand
A – Tabs (one hidden)
B – Locking Tab
3.
Lift the system unit off the stand.