5-34 Installing Options
Locating minitower expansion board slots
A – ISA Slot
C – PCI Slots
B – PCI/ISA Slot
Installing an Expansion Board
To install an expansion board in the system, perform the following steps.
1.
Remove the system unit cover (see “System Unit Cover”).
2.
Follow any preinstallation instructions that come with the expansion
board (such as setting switches or jumpers on the board).
Note
Before installing the expansion board, you must remove the AGP
board (if installed) and the chassis floor (see the sections “AGP Board
Removal” and “Chassis Floor”).
3.
Remove the screw securing an expansion slot cover (see the
following figures). Set the screw aside (it will be used to secure the
expansion board).
4.
Remove the slot cover. Save it to cover the slot again in case the
expansion board is removed.