Installing Options 5-53
Aligning the desktop front panel
4.
Replace the system unit cover (see “System Unit Cover”).
Removing the Minitower Front Panel
Remove the front panel before installing a device in one of the 5 1/4-inch
accessible device slots. The front panel does not need to be removed if
you are installing an internal
3 1/2-inch hard drive. If you are going to install an accessible 5 1/4-inch
device, you also need to remove the blank panel that covers the slot on the
front panel.
To remove the front panel, proceed as follows.
1.
Remove the system unit cover (see “System Unit Cover”).
2.
Squeeze the locking tab on the lower left corner on the back of the
front panel (see the following figure).
Note
The front panel has one locking tab on the bottom left that must
be squeezed before the panel can be removed. The five pop-in tabs insert
into the holes in the chassis.
3.
Remove the front panel by releasing the locking tab and five pop-in
tabs from the back of the front panel.