Setting Up the System 2-3
!
Connect the printer cable to the printer port on the rear of the system
unit. Secure the cable with the screws provided. Connect the other end
to the printer.
!
Connect one end of the serial cable to one of the two serial ports on
the rear of the computer. Secure the cable with the screws provided.
Connect the other end to the serial device.
!
Connect one end of the USB cable to the USB port on the rear of the
computer. Connect the other end to the USB device. See the
documentation that comes with your device to connect additional USB
devices.
!
Connect one end of the SCSI cable to the SCSI connector at the rear
of the system unit. Connect the other end of the cable to either of the
SCSI connectors on the SCSI device. See the documentation that
comes with your device for instructions on jumpering and terminating
the device.
!
Set the voltage switch correctly for your area. The correct setting for
the U.S. and Canada is 115V.
Set the voltage switch correctly for your area.
!
Connect the power cable to the system power socket at the rear of the
system unit. Connect the other end to a surge protector
(recommended) or a properly grounded wall outlet.
NECC recommends connecting the power cable
to a surge protector.