4-30 Installing Options
!
Save the rails and bay cover for later use. They are used to cover
an empty bay.
Note
Always keep unused NEC rails and bay covers. The bay cover
cannot be replaced if there are no rails.
Removing a 5 1/4-inch device bay cover
3.
Install the rails on the 5 1/4-inch device if there are none or if the
rails on the device are the wrong type.
!
Check the device to ensure that the rails are the correct type. The
rails must be identical to those just removed from the bay.
!
If the rails installed on the device are correct, go to step 4.
!
If the rails are not correct, remove the two or three screws
fastening each rail to the device, and remove the rails (see the
following figure, “Locating the device rails and screws”).
!
Fasten the rails you removed from the bay to the sides of the
device.
