4-32 Installing Options
6.
Slide the device into the empty bay until it clicks in place.
7.
Connect the signal and power cables to the back of the device.
!
Locate an unused signal connector on the primary or secondary
interface cable and plug the connector into the connector on the
back of the device. (See the figure “Locating system board cable
connectors” for IDE cable connector locations.)
!
Locate an unused power cable of the proper length and plug its
connector into the power connector on the back of the device.
8.
If you are installing a CD-ROM, CD-RW, or DVD-ROM drive and
you have speakers, connect the drive’s audio cable to the CD IN
connector on the system board or optional sound board.
9.
Replace the front panel and the cover (see “System Unit Covers”).
Removing a 5 1/4-Inch Accessible Device
If you are removing a 5 1/4-inch accessible device, either to replace it
with another device or to leave the bay empty, use the following
procedure.
1.
Remove the system unit cover and front panel (see “System Unit
Covers”).
2.
Tag and unplug the signal and power cables from the back of the
device.
3.
Press in on the tab on each side of the device and pull the device out
of the bay.
