Installing Options 4-33
Removing a 5 1/4-inch device
4.
Remove the two rails from the device by removing the screws
securing the rails to the sides of the device (see the figure “Locating
the device rails and screws” earlier in this section). Save the rails.
Note
Always keep unused NEC rails for installation on devices without
rails or that have the wrong rails. Also, you need the rails to install the bay
cover.
5.
If you are installing a new device in the bay, see “Installing a
5 1/4-Inch Accessible Device.”
6.
If the bay is to remain empty, install the rails and bay cover as
follows.
Note
The rails and bay cover must be installed in an empty bay to
maintain EMF protection, keep dust and dirt out, and ensure proper
system unit cooling.
!
Position the rail between the two guides in the bay, as shown in
the following figure.
!
While holding down on the rail, pull up slightly on the tab and
slide the rail into the bay until the rail locks in place.
