4-38 Installing Options
Securing the Zip drive
A – Zip Drive
B – Screws
Removing a 3 1/2-Inch Accessible Device
If you are removing a 3 1/2-inch accessible device, either to replace it
with another device or to leave the bay empty, use the following
procedure.
1.
Remove the system unit cover and front panel (see “System Unit
Covers”).
Before removing the cover, turn off system
power and unplug the system power cable. Power is removed only when
the power cable is unplugged.
2.
Tag and unplug the signal and power cables from the back of any
devices in the two-drive bracket.
3.
Press in on the tab on each side of the bracket and pull the bracket out
of the bay (see the figure “Removing the two-device bracket” for tab
locations).
4.
Remove the front cover from the bracket by pressing in on the
cover’s two tabs (see the figure “Removing the bracket cover” for tab
locations).
5.
Remove the three or four screws fastening the device to the bracket
and slide the device out of the bracket.
