4-46 Installing Options
6.
Reinstall the 5 1/4-inch two-device bracket in the bottom bay by
sliding the bracket into the bay until it latches in place. (See the
following figure for bracket placement.)
7.
Reinstall all other 5 1/4-inch devices by sliding each into its bay until
it latches in place. (See the following figure for device placement.)
Accessible device placement for a minitower
A – 3 1/2-Inch Bracket
B – 5 1/4-Inch Bays
8.
Reinstall any rails and bay covers. The bay cover(s) and rails must be
installed in all empty bays to maintain system integrity.
!
Slide each rail into its slot until it latches in place (see “step 6 in
“Removing a 5 1/4-Inch Accessible Device” for details).
!
With the arrows on the sides of the bay cover pointing towards
the top of the chassis, align the cover with the two rails, and
press the cover in until it locks in place against the chassis (see
“Removing a 5 1/4-Inch Accessible Device,” step 6, for details).
9.
Connect all signal and power cables to the devices.
10.
Reposition the logo plate on the front cover.
!
Unclip the logo plate tabs from inside the front panel.
!
Reposition the logo plate so it is readable when the chassis is in
the horizontal position.
!
Press the tabs into the front panel until they click in place.
