Configuring the System 3-31
Set the jumpers as follows.
1.
Power off and unplug the system and any external options. Remove
the system cover (see “Removing the Cover” in Chapter 4).
2.
Locate the appropriate jumper on the system board (see the previous
figure “Locating the System Board Jumpers”).
3.
Move the appropriate jumpers for your application as shown in the
following table, “Setting system board jumpers.”
Before setting jumpers, we recommend that you
first contact NECC for assistance (see Chapter 6 for contact information).
The system power must be off before changing
a jumper setting.
4.
Check your settings to be sure that they are correct for your
application.
5.
Replace the system cover (see “Replacing the Cover” in Chapter 4).
Connect system power cables and external options.
6.
Power on the system and launch the BIOS Setup Utility before POST
and recustomize your BIOS settings as necessary.
