Installing Options 4-15
Installing the Expansion Board Retainer Bar
Install the expansion board retainer bar as follows.
1.
Hold the retainer bar at an angle and insert the ends into the slots in
the chassis (see the following figure).
2.
Push the bar into the slots and under the edge of the chassis.
3.
Press down on the lock tabs and firmly push the bar in until the tabs
slide into their slots. Check that the raised portion on each tab locks
into its slot.
4.
Replace the cover (see “Replacing the Cover”).
Installing the expansion board retainer bar
A – Retainer Bar End
C – Lock Tab
B – Retainer Bar Slot
D – Lock Tab Slot
