NEC PowerMate CT 815 Release Notes 5
3.
From the System Properties box, click the
Network ID
button. The Network Identification
Wizard launches.
4.
Follow the instructions to set up your network type and/or workgroup. Get this information
from your system administrator.
5.
When you have completed the wizard setup, click
Finish
. At the message, “You must
reboot this computer for the changes to take effect,” click
OK
.
6.
At the System Properties screen, click
OK
.
7.
Click
Yes
to restart your system.
TCP/IP Setup
Use the following procedure to set up TCP/IP.
1.
From the Windows desktop, click
Start
on the taskbar, point to
Settings
, and click
Network
and Dial up Connections
.
2.
Click
Add Network Components
.
3.
From the Windows Optional Network Components Wizard, highlight “Networking
Services,” then click the
Details
button.
4.
Check the box for “Simple TCP/IP Services.” Click
OK
.
5.
At the Windows Optional Networking Components Wizard, click
Next
.
6.
At the instruction to insert the Disc labeled “Windows 2000,” click
OK
.
7.
At the Files Needed box, change the “Copy files from” information to
C:\i386
. Click
OK
.
8.
Reboot your system for the changes to take effect.
TCP/IP Configuration for DNS
The Microsoft Windows 2000 operating system has an extensive Help file. Use the
Windows 2000 help to set up DNS.
Reinstalling Service Pack 6a on Systems with the Windows NT Operating
System
Any time you change the state of a system with the Windows NT operating system, such as
when you install a new protocol, device, or service, you must reinstall Service Pack 6a.
Reinstalling Service Pack 6a updates all essential files for the new system configuration. Service
Pack 6a is on the NEC PowerMate Series Application and Driver CD that comes with your
computer.
Use the following steps to reinstall Service Pack 6a.
1.
Insert the NEC PowerMate Series Application and Driver CD into the CD-ROM drive.
2.
Double click
Service Pack 6a for Windows NT
.
3.
At the Windows NT setup screen, check mark the License agreement to start the
installation.
4.
When the installation is done, remove the Application and Driver CD. Click
Restart
.
