3-8
Disassembly and Reassembly
Removing the Expansion Board Retainer Bar
Expansion boards and slot covers are held in place by an expansion board retainer bar. Remove
and replace the retainer bar as follows.
1.
Remove the cover (see “Removing the Cover” earlier in this section).
2.
Press down on the two tabs on the retainer bar to release the tabs from their slots. Carefully
remove the bar from the chassis.
Removing the Expansion Board Retainer Bar
A
– Retainer Bar Tabs
B
– Tab Slots
3.
If you are removing an expansion board, see “Removing an Expansion Board,” next.
4.
If you are adding an expansion board, see “Installing an Expansion Board” later in this
section.
5.
To replace the retainer bar, see the following section.
Replace the retainer bar as follows.
1.
Hold the retainer bar at an angle and insert the ends into the slots in the chassis (see the
following figure, “Replacing the Retainer Bar”).
2.
Push the bar into the slots and under the edge of the chassis.
3.
Press down on the lock tabs and firmly push the bar in until the tabs slide into their slots.
Check that the raised portion on each tab locks into its slot.
4.
Replace the cover.
Summary of Contents for POWERMATE CT 815 - RELEASE NOTES
Page 13: ...1 System Overview Configurations Features Components Software...
Page 106: ...6 Preventive Maintenance System Cleaning Keyboard Cleaning Mouse Cleaning...
Page 109: ...7 Troubleshooting Checklist Diagnostics...
Page 118: ...8 NECC Information Services Service and Support Functions Technical Support...
