3-14
Disassembly and Reassembly
Removing the Fan, Heat Sink, and Processor
A
– Heat Sink
D
– Processor
B
– Retention Clip
E
– Retention Clip Flange
C
– Lock Lever
Installing the Processor
Install a processor as follows.
1.
Remove the processor from the system (see “Removing the Processor” in the previous
section).
Before picking up the processor, reduce static discharge by touching
the metal chassis.
2.
Align the notch on the corner of the processor with the notch on the socket.
3.
Carefully align the processor pins with the socket pin holes and set the processor into the
socket.
!
If aligned correctly and the pins are not bent, the processor seats in the socket without
forcing.
!
If the processor does not seat, check for correct alignment and bent pins.
4.
Pivot the lever down and press it in towards the socket until it locks in place.
Using the wrong heat sink or no heat sink can damage the processor,
system board, or both. Ensure that the update processor has the correct heat sink (refer to the
documentation that comes with the kit).
Additional information can be obtained from NECC (see Section 8, “NECC Information Services,”
for information on contacting NECC).
Summary of Contents for POWERMATE CT 815 - RELEASE NOTES
Page 13: ...1 System Overview Configurations Features Components Software...
Page 106: ...6 Preventive Maintenance System Cleaning Keyboard Cleaning Mouse Cleaning...
Page 109: ...7 Troubleshooting Checklist Diagnostics...
Page 118: ...8 NECC Information Services Service and Support Functions Technical Support...
