5-12 Repair
4.
Slide the 3 1/2-inch diskette drive out of the slot in the front of the chassis.
5 1/4-Inch Device Removal
Remove a 5 1/4-inch device (CD-ROM reader or other device) from the 5 1/4-inch device
cage as follows.
1.
Remove the system unit cover and front panel as previously described.
NOTE:
The 5 1/4-inch devices are installed with
drive rails.
2.
Disconnect the device signal and power cables from the inside of the system unit.
(If removing a CD-ROM reader, also disconnect the audio cable.)
3.
Remove the device as follows:
n
If removing the device from the top 5 1/4-inch slot, remove the four screws,
two to a side, that secure the device in the cage (see Figure Section 5-14 and
Figure Section 5-15).
n
If removing a device from the middle or bottom 5 1/4-inch slot, remove the
two screws that secure the device in the cage (see Figure Section 5-14).
n
Slide the device out from the front of the system unit.
Figure Section 5-13 Diskette Drive Bracket Screws
